Hope this solution able to solve your problem. The key is shipped on the rear of the workstation. When installing the fan, it must blow toward the rear of the chassis, so be sure that the airflow direction arrow on the side of the fan housing faces the rear of the chassis. Universal Chassis Clamp Lock Optional If a universal chassis clamp lock is installed, remove it before servicing the unit. You can set this to notify a user if the access panel has been removed.
Quadro cards are for workstations that are for 3D modeling and things of that nature. If you install a non-PnP device, you must reconfigure the workstation after completing installation of the new hardware. Cables and Connectors Cables must be handled with care to avoid damage. Push the hood sensor down and remove it from the chassis. But you probably end up at the computer store where technicians can take a look at it. Attach the rails to the hard drive by first inserting the hard drive rail assembly pins into one side of the hard drive screw holes. Keep this number available when contacting customer service for assistance.
Any drive attached to a controller must have a drive designation. The following table describes what each color signifies. Slide the workstation into the rack until it stops. Our came with a promise sata raid controller. Compaq racks use M6 screws and clip nuts, and many third-party racks use 10-32 screws and clip nuts.
The correct printer driver for Install the correct printer driver for the application. A properly seated processor does not lift out of the socket. Our came with a promise sata raid controller. Solving Minor Problems Table 5-3 Minor Problems Problem Cause Possible Solution Workstation appears locked up Software control of the power Press and hold the power button for at least four and will not turn off when the switch is not functional. Trademarks: Microsoft Windows logos are registered trademarks of Microsoft.
The battery in this system is a lithium battery that does not contain any heavy metals. Posted on Jul 22, 2009 You can create 1 domain server in 1 computer. Turn off the workstation and any peripheral devices that are connected to it. To test the power supply: Disconnect all internal power supply cables. Select a setup configuration to copy. When a device is selected, detailed information and options are displayed.
Let the system automatically installed the printer driver to your workstation computer. Then, fully extend the slides, press the release button, and slide the unit all the way back into the rack. Factory-installed drives ship with the jumpers preset to the cable-select mode;. Being an easy-to-use utility, The Drivers Update Tool is a great alternative to manual installation, which has been recognized by many computer experts and computer magazines. The serial number labels are located on the side panel of the unit and on the rear panel. The following packaging and grounding precautions are necessary to prevent damage to electric components and accessories.
Lightly press down on the top of the processor while closing the socket lever. The version with a cable additionally prevents entire system theft and allows multiple systems to be secured with a single cable. Let me know if you need further assistance. Under Error-checking, click Check Now. To install the front fan, reverse the previous steps. Close any open software applications. The following options might be presented: Hard Disk Identifies the hard disk drives on the system.
Handle cables by the connector or pull strap whenever possible. Removal and Replacement of Components This section discusses the procedures necessary to remove and install various hardware components on your workstation. These tabs separate the major functions of Insight Diagnostics. A Complete Test provides a predetermined script where each hardware component is fully tested. Handle them only at static-free work areas. Verify that the monitor is attached and turned on.
For that you need to buy windows 2008 enterprise edition with 25 user license so you can use server with 25 workstation limit. Printer is not turned on and Turn the printer on and be sure it is online. Reseat the graphics card if applicable. Press and hold the power button for less than four seconds. To avoid bending the processor pins, keep the processor perfectly flat when removing and storing it. To remove the cable lock, unlock it and pull it out of the cable lock slot as shown in the following image. Place the next page on the bottom of the rack or on top of an already installed unit in a rack.