If the specified free play cannot be obtained as de- scribed above or if the clutch does not operate cor- rectly, have a Yamaha dealer check the internal clutch mechanism. To open it you should use Adobe Reader. The headlights and taillight come on when the light switch is on, and the engine can be started. Install the washer onto the air filter element 11. Remove the spark plug cap and spark Short-term plug. Skip steps 7—10 if the oil filter element is not being replaced. After extensive tests, only the tires listed below have been approved for this model by Yamaha Motor Co.
Connect the air intake duct to the throttle Air filter case holding plate bolt: body, and then tighten the clamp screw at the 7 Nm 0. To raise a headlight beam, turn the headlight beam adjusting bolt in direction a. Have a Yamaha dealer adjust the position of the handlebar. Install the air filter case holding plate by install- Tightening torque: ing the bolts and collars, and then tighten the Locknut: bolts to the specified torque. If you stall or roll Always use the size and type of tires specified in backwards, follow the special procedure for this manual.
To reduce your risk of drowning or other injuries, use care when crossing through water. Remove the oil filter element cover by remov- ing the bolts. No brake lever free play maintenance and lubrication chart. Install the crankcase engine oil drain bolt, the engine oil tank drain bolt and their new gasket, Be sure to wipe off spilled oil on any parts after the and then tighten the bolts to their specified engine and exhaust system have cooled down. Since heat and deposits will cause any spark plug to slowly erode, the spark plug should be removed and checked in accor- 1. Remove the tailpipe by pulling it out of the 4.
Air filter case cover holder 1. Go straight 8 Never operate on excessively rough, slippery or down the hill where possible. The shorter distance A is, the higher the spring preload; the longer distance A is, the lower the spring preload. Insert the tailpipe into the muffler and align the muffler. Remove the headlight bulb holder by pushing it in and turning it counterclockwise, and then remove the burnt-out bulb. If operation is not smooth, have a Yamaha dealer check the vehicle. Raise the pedal the engine by pushing the start switch.
Distance between brake lever and handlebar grip 1. If the cable length cannot be adjusted to specifica- Check to make sure there is no brake drag. Remove the fuel tank cap by turning it coun- terclockwise. Damage to the engine or es, the two rear wheels turn together at the same drive train may occur. .
Loosen the rear wheel axle pinch bolts. For parts equipped with a grease nipple, use a grease gun. Otherwise, fuel and may cause loss of consciousness and may leak out of the carburetor or fuel tank. These labels contain important information for safe and proper operation. Be sure to keep your feet firmly mounted on the footrests at all times.
Wash the sponge material gently but thor- 6. The fuse holder is located under the seat. Do not overfill the fuel tank. Never go over the top of any hill at high speed. Cargo should be properly distributed and the procedure described in this manual. If coolant is not available, tap water can be temporarily used instead, provided that it is changed to the rec- ommended coolant as soon as possible. Turn the adjusting nut while holding the brake light switch in place.
Certain reduce the chance of skidding or sliding out of maintenance can only be carried out by certified control. To install one of the panels 2. When refueling, be sure to insert the pump nozzle into the fuel tank filler hole. See page 6-1 for a description of the ignition circuit cut- off system. To install the panel 1. Remove the bolts, and then remove the air fil- ter case by disconnecting it from the air intake duct.